An image created using a version of the Christmas star from Follow Him and the praying figure from ACTS. This image is printed twice on an A6 sheet, so it can be cut in half and used on two candles or both sides of one candle.

Instructions for use:

• Trim the excess un-printed film, cutting both the transfer film and its backing paper together.
• Soak the transfer in a bowl of water until the transfer film starts to move off the paper backing. You can feel it start to move when held between finger and thumb.
• Lift the transfer and paper backing out of the water and slide a small amount of the transfer onto the surface of the candle. Hold the top left corner and pull the backing paper out from the transfer allowing it to settle onto the candle.
• If you need to adjust the positioning then move carefully by holding opposite corners and push/slide the transfer. Try not to move it too far as the transfer may ruckle.
• Holding the transfer at the top left or top right, use a soft cloth to squeeze out air bubbles and water moving diagonally across the transfer.
• Leave to dry for at least 6 hours before using the decorated item.